Solved: Thanks to Telenor advice. :
The updates should take effect immediately .
You can the payload as a respource :return { payload: payload.toString(“utf8”)};
And then export the payload and look at it that way.
In my case ‘”‘ had become ‘””‘ between my thing and the uplink.

Using the Arduino NBScanNetworks example I get a list of available networks :

11:00:59.833 -> NB IoT/LTE Cat M1 networks scanner
11:03:51.730 -> NB IoT/LTE Cat M1 networks scanner
11:04:09.026 -> Modem IMEI: 352753095031249
11:04:09.060 -> Current carrier: 242 01 Telenor
11:04:09.093 -> Signal Strength: 22 
11:04:09.126 -> Scanning available…

[Read more]

The SIM was activated as confirmed by m2m. So I am still interested in how to debug this situation
deep into MKRNB bind. I can not imagine that I don’t have LTE-M or NB-IOT in the middle of Trondheim ?

I contacted Telenor phone support(Saturday) that told me that the SIM was not activated,
so I will contact iotsupport on email!

When using Radio Access Technology 8 (NB-IOT) I only get to AT+CFUN=0
in NBAccess.begin.

The status of the sim shouldn’t affect the modems ability to process AT commands, it should respond even without a simcard. Have you tried interfacing with the modem directly using the serial monitor of the Arduino IDE or a terminal like putty? If you’ve tried to run code without monitoring the serial output, keep in mind that lines like while…[Read more]

Hi Steffen

I’ve written a control application for a Wallas heater on an D1 Mini NodeMcu WIFI ESP8266. The application is communicating with a MQTT broker on a Raspberry PI via MQTT over WIFI. I bought the StartIOT Arduino MKR NB 1500 Dev-Kit to build a communication solution to control the application from remote. The Raspberry PI and the Arduino…[Read more]

selvsagt LF/LFCR ikke LF/LFRF

Hey Eystein.

First of all, lets get some assertions out of the way. As you have been trying different program we can assert that you have a working usb connection and can program the Arduino unit. I assume you are using the Arduino IDE. Do you use the same baud rate in the program and while communicating with the program (say 9600 or 115200)? Can…[Read more]